|
|
| ELK M1 Wireless Receiver for GE Crystal Transmitters
|
|
|
|
|
Product Details
ELK M1 Wireless Receiver for GE Crystal Transmitters
The ELKM1XRFEG is a Wireless (RF) Receiver and Input Expander for use with the ELK-M1 and ELK-M1EZ8 Controls. The receiver connects to the four (4) wire data (keypad) bus of the control and integrates in much the same way as a M1XIN hardware zone expander except that a single M1XRFEG can handle up to 144 wireless zones (e.g. transmitter sensors or points).
The benefits of operating from the data bus are:
1) A receiver can be installed virtually anywhere in the building for convenience and optimum coverage.
2) Multiple receivers (up to 11 total) can be connected to a single control for ultimate range and/or coverage redundancy.
The major benefit of having multiple M1XRFEG receivers is that hundreds if not thousands of square feet can now be covered by strategically placing each receiver in a different geographic location.
The M1XRFEG receiver uses Crystal frequency technology and is a dual (2) antenna, phase
diversity design capable of long range wireless coverage.
The M1XRFEG is ONLY compatible with the 319.5MHz Crystal based
transmitters available from GE.
FEATURES:
- Adds up to 144 individual wireless zones (sensors/points)
- Operates from the 4 wire RS485 Data Bus
- Additional Receivers (up to 11) may be Connected to a single M1 or M1EZ8 Control for
redundancy or greater coverage
- Flash Memory for Updating of operating Firmware
SPECIFICATIONS:
- Sensitivity: >105 dbm
- Operating Temperature: 0 to +120 degrees F
- Operating Voltage: 12 Volts D.C.
- Current Draw: 70mA
- Range: 300 to 500 ft. line of sight (Up to 1000 ft. with ground plane antennas)
NOTE: Walls or metal may reduce actual operating range.
Purchase the ELK Crystal Wireless Receiver, Input Expander (ELKM1XRFEG) and you are guaranteed to save.
Find thousands of home automation products at the guaranteed lowest price, only at DiscountHomeAutomation.com
|
|
|
|
|
|
