|
|
| RCS Thermostat with RS485 Interface
|
|
|
|
|
Product Details
RCS Thermostat with RS485 Interface
TR16 Industry Leading Two Part Design!
The TR16 Thermostat is a two-part product, consisting of a Wall Display Unit (WDU)
and an HVAC Control Unit. This design makes installation fast and easy. NO NEW
WIRES to run to the wall mounted display unit.
WDU: The WDU is the typical thermostat user interface and mounts in the usual
thermostat location. It includes a large, easy to read, digital LCD display with
continuous backlight, control buttons and temperature sensor.
The WDU also has on-screen setup of sensor calibration, F or C mode, and network
address. Includes optional remote sensor terminals.
HVAC Control Unit: The Control Unit is mounted at the HVAC system and allows
connection to the communications network in a convenient location without running
new wires out to the wall unit.
HVAC System Compatibility
Works with all HVAC systems, both Standard Gas/Electric and Heat Pump, and supports multistage
units.
- Central HVAC systems or separate heating/cooling systems with separate RH/RC
transformers.
- Standard gas/electric HVAC Systems: Two-stage heating. Two-stage cooling.
- Heat Pump HVAC Systems: Three-stage heating. Two-stage cooling.
- Fan system: Selectable for standard or fan with heat for electric heat systems.
- Heat Pump Change Over valve (reversing valve): Selectable for change over with heat or
change over with cool (O or B output).
- Emergency Heat: In Heat pump mode, Emergency Heat mode is selectable from the wall
display unit.
- Compressor short cycle protection delay of 5 minutes.
Remote Sensors
The TR16 supports up to 2 indoor remote sensors. It features ôauto detect" of any remote sensor
connected and automatically configures the system for their use. The remote sensors have address
switches allowing them to be configured as (1) remote only, (2) remote averaged with internal
sensor, (3) remote 2 averaged with remote sensor or internal sensor, plus an (4) outside temp
sensor. Refer to RCS remote sensors such as the RS15 wall mount sensor.
Serial Communications Interface
The TR16 has RS485 network communications. Communications setup is 9600 baud, 8 bits, no parity
and 1 stop bit. Supports RS485 network addresses up to 99 thermostats. Uses simple ASCII protocol
supported by virtually all control systems.
Wiring: Wiring between the Wall Display Unit and the Control Unit is four wires, which can
be thermostat wiring, Cat 3 or 5 cables. Wiring from the Control Unit to HVAC system is standard
thermostat wiring (18Ga, solid), using standard thermostat connections.
Features:
- Independent Heat and Cool Set points!
- Supports up to 3 Stage Heat, 2 Stage Cool!
- RS485 Network Interface
- For Standard or Heat Pump Systems
- NO NEW WIRES for Retrofit Applications.
- LCD Display with Continuous Backlight
- Local Control of All Thermostat Functions
- Remote Control of All Thermostat Functions
- Optional Remote Sensors
- Optional Outside Temp Display
- Network Addressing to 99 thermostats
- CommStar Network and WinEVM Compatible
- Power: 12VDC, Transformer supplied
- Size: WDU: 5"x3"x3/4". Control Unit: 6"x4" x2"
Purchase the RCS Thermostat with RS485 Interface (RRCTR16) and you are guaranteed to save.
Find thousands of home automation products at the guaranteed lowest price, only at DiscountHomeAutomation.com
|
|
|
|
|
|
