Features

• Allows multiple phones and data cards to be used simultaneously
• Supports CDMA, TDMA, GSM and AMPS, in addition to 1x and 3x data protocols such as HSDPA, EVDO and EDGE
• Up to 3 watts maximum output power
• Power control logic ensures maximum output power is within cellular standards
• Requires no physical connection to cell phone or data card
• Provides high signal-to-noise ratio
• Protects cell sites from harmful interference
• Includes our high efficiency 12” exterior magnet mount antenna (301103)
• Dual band - Cellular and PCS
• FCC and IC type accepted

Specifications

• Part Number: 801212
• Frequency: 824-894 MHz / 1850-1990 MHz
• Gain: 40 dB / 45 dB
• Max Output Power: 3 watts
• Max RF: +35 dBm / +10 dBm
• Noise Figure: 3 dB nominal
• Flatness: ± 3 dB / ± 4 dB
• Isolation: > 90 dB
• Power Requirements: 6 V, 3 A max
• Connectors: FME-Male 50 ohms
• Dimensions: 4.5 x 3.5 x 1.25 (inches) / 11.43 x 8.9 x 3.2 (cm)

How it Works
The Wilson amplifier has been carefully engineered to significantly improve the performance of your cell phone or cellular data card in mobile applications. Together with an outside antenna (sold separately), the amplifier’s state-of-the-art technology is designed to increase your signal up to 10 times, reduce disconnects and dropouts, and increase data communication rates needed for 3G technologies.

The outside antenna will collect the cell tower signal and send it through the cable to the amplifier. The signal is then boosted and sent through the inside antenna. Your cell phone or data card then communicates with the improved signal. When the cell phone or data card transmits, the signal goes through the inside antenna, is boosted by the amplifier and broadcast back to the cell tower through the outside antenna.