|
|
| X10 Activated Pool/Spa Controller
|
|
|
|
|
Product Details
X10 Activated Pool/Spa Controller
Get X-10 Control for your Pool or Spa! The X-10 Pool/Spa Controller is either in the Pool Mode or Spa Mode. Any of the 256 X-10 codes can be used as "X-10 Identification (ID) Codes" to activate each Mode and other features of the Controller. The Controller transmits two of these ID Codes to X-10 modules wired to the Filter and Cleaner Pumps. The Filter Pump can instead be wired to an external contactor (24 VAC coil, 30 amp contacts) directly connected to a 24 VAC output provided by the Controller; transmitting the Filter Pump X-10 ID Code will then turn the Filter Pump on or off. If an X10 ON command is sent from an outside source to turn on the Cleaner pump and the Filter Pump is not on first, the Controller will automatically transmit an X-10 Off command to the Cleaner Pump.
Features
- A single X-10 command activates the Spa Mode to: 1) rotate valve actuators, 2) turn on the heater and 3) turn on the Filter Pump
- Heat Boost: turns heater on temporarily for 2 minutes
- Auto Spa Shut Off: automatically turns Spa off if desired
- Heater Cool Down: allows heater to cool down after using Spa
- Memory: the controller remembers whether it was in the Pool or Spa Mode in case of power failure
- Filter Pump: can either be wired to an X-10 module or an external contactor connected directly to the Controller.
- Auto Filter Pump Shut Off: automatically turns the Filter Pump off if desired
- Cleaner Pump Safety Interface
Purchase the X10 Activated Pool/Spa Controller (MMIPSC) and you are guaranteed to save.
Find thousands of home automation products at the guaranteed lowest price, only at DiscountHomeAutomation.com
|
|
|
|
|
|
