• Home
  • Linear DX Receiver, 2-Channel (Open Box)

Linear DX Receiver, 2-Channel (Open Box)

$48.24 $76.00
SKU: LNDXR702_OB

1 available at this price.

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov

Product Description

The DXR-70 is a Digital Receiver with one or two isolated relay outputs designed for use with Linear's DX Format transmitters. This receiver can be used in a variety of remote control applications. When the receiver detects a signal from a transmitter programmed into its memory, the appropriate relay output activates. The relays have four optional output configurations.

In a typical installation, the receiver is connected to an alarm control panel, door strike, camera, high current relay or some other device(s). Transmitter(s) are used to activate or control the devices. The receiver should be mounted with the supplied mounting bracket indoors or outdoors inside a weather resistant non-metallic housing.

The digital DX code format features over a million possible codes. The DX transmitters are precoded at the factory to unique codes, so no field coding is required. Receivers must be programmed to the transmitter's code before system testing and operation. Up to 32 transmitters maximum can be programmed into the receiver.

Tech Specs

  • Part Number: SNR00149
  • UPC: 093863102752
  • Operating Frequency: 315 MHz
  • Data Format: DX format
  • Number of Codes: 1,048,575
  • Measured Range: 700 feet in one quadrant with DXT-21 transmitter; 500 feet in open air (four quadrant test)
  • Operating Temperature: 32° to 120° F (0° to 49° C)
  • Sensitivity: -95 dBm (typical)
  • Number of Stored Transmitter Codes: 32 per receiver
  • Receiver Output: For "C" relay contact, 1 amp, at 32 VDC per channel
  • Field Selectable Receiver Output Modes:
    • Momentary, 4-second (factory set)
    • Momentary, 1-second
    • Flip-flop toggle
    • latch/restore, 2-channel only

Mode Button (one per channel)

  • Learn Mode: Press and release to enter learn mode
  • Transmitters Learned: Press and hold for five seconds after the last LED flash to delete all transmitters on an associated channel
  • Erase Memory: Press and hold for five seconds after the last LED flash to delete all transmitters on an associated channel
  • Clear Latch: Press and release
  • Clear Low Battery: Press and release mode switch on channel 2 (DXR-702 only) to clear low battery

LED Indicator

  • Steady: Indicates "learn" mode
  • Flashing: Indicates number of transmitters learned on the selected channel
  • RF Activity: Blinks synchronously with detected RF activity
  • Antenna: Wire lead
  • Input Impedance: 75 Ohm – 2:1 VSWR
  • Operating Voltage:
    • 11 to 17.5 VDC
    • 12 to 16 VAC
  • Current:
    • 25 mA at standby at 12 VDC
    • 60 mA in alarm at 12 VDC
  • Connectors: Screw terminal,+,-, with N/O, N/C, and common per receiver channel
  • Acessories: Mounting bracket, screws, and anchors (supplied)
  • Regulatory Requirements: FCC and DOC
  • Dimensions: 5.5" W x 4.0" H x 1.25" D (140 x 102 x 32 mm), excluding antenna