PCS PulseWorx UPB Relay Wall Switch, 15A
Product Description
The WS1R was designed to switch instant-on/off of lighting loads. It has a built-in relay (15A rating) to control different sources on the market today. Limited not only to lighting, but also motors, pumps, or ceiling fans that may hum when using a dimming switch.
This profile provides instant-on/off ability to handle heavier loads up to 15A rating. Available in seven colors: white, light almond, almond, ivory, brown, gray, and black to match practically any décor.
- Built-in relay provides instant-on/off ability
- Limited not only to lighting control, but also other house appliances (up to 15A rating)
- Adjustable LED brightness and backlighting permits night time viewing and status
- Works along side with RWS with traveler wire.
- Available in 7 colors
Tech Specs
- Part Number: WS1R-15
ELECTRICAL
- Power Requirements: Primary: 120 Volts AC, 50/60Hz
- Neutral Wire: Required
- Load Type: Motor, Inductive, Incandescent, LED
- Transmission Channels: 2 Links/Scenes
- Connections/Power Wire: Two 16 AWG gauge, 105 C insulation; Black – Hot/Line; White – Neutral; Red – Load; Yellow – traveller (controlled by RWS)
- Standby Power Consumption:< 0.8 Watts
- Environmental Conditions: Indoor Use Only
- Operating Temperature: -40 to 140 degrees F (-40 to 60 degrees C)
- Operating Humidity: 10 to 90 percent RH (non-condensing)
- Certifications: Safety tested for USA and Canada to ETL tested to UL508; UL-508-2010 CSA C22.2 #14-2010
OPERATION
- Status LED Modes: All programmable with UPStart Blue, Red, Magenta or Off
- During Power Outage: Retains all settings in Non-volatile EERPOM
- Setup Mode: Tap Top or Bottom Rocker 5 Times – LED will Blink
MECHANICAL
- Button Type: 2 Momentary contact type buttons
- Wire Nuts: 4 included
- Mounting: Single Gang or multiple-ganged junction box
- Dimensions: 4.25(H) x 1.7(W) x 1.37(D) inches
- Weight: 5 ounces
- Warranty: 5 years