PCS SimpleWorx Sunrise Sunset Timer
Product Description
The Sunrise Sunset Timer (SST) turns 120VAC devices ON and OFF based on one of the (10) ten preset daily schedules. It can be controlled remotely with digital SPC™ (Simple Powerline Communication) commands from up to eight different SimpleWorx Transmitters. It also has a manual override button located on the device.
The Timer's astronomical clock is capable of tracking Northern and Southern latitudes from 0 – 60 degrees and Eastern to Western Longitudes from 60 -125 degrees, plus 135 & 165 degrees to include Hawaii and Alaska. The on board clock automatically adjusts for Daylight Saving Time and Leap Year.
The heavy duty 125mA battery will protect the factory set clock and last saved settings for 10 years in the event of power failure. Pressing a button sets the schedule, time zone, daylight savings mode, and location latitude and longitude.
FEATURES:
- Pass-Thru Outlet (Always On)
- 10 On/Off daily programs
- Daylight Savings and Leap Year Compensation
- Remotely controllable from up to eight SWX Transmitters; no control wiring
- Manual Override Button
Tech Specs
- Part Number: SWX-SST
- Power Requirements: Primary: 120 Volts AC, 50/60Hz Single Phase
- Neutral Wire: Required
- Channels: 1
- Switch Load Types: Standard inductive loads up to 15A and incandescent loads up to 800W
- Relay Lifetime: 100,000 on/off operations at full electronic ballast load
- Max Load: 15 Amps at 120VAC 50/60 Hz
- Standby Power Consumption:< 0.8 Watts
- Environmental Conditions: Outdoor Water Resistant Use Only
- Temperature: -40 to 140° F (-40 to 60° C)
- Humidity: 10 to 90% RH (non-condensing)
- Certifications: Safety tested for USA and Canada ETL tested to UL508; UL-508-2010CSA C22.2 #14-2010
- Status LED Modes:
- Red = Operation Mode
- Blinking Green = Link Mode
- Blinking Red = In Programming Mode
- Blinking Orange = In Re-Schedule Mode
- Slowly Blinking Red = Temperature Protection is Activated
- During Power Outage: Retains all settings in Non-volatile EERPOM
- Set Button: Button
- Mounting: 3-pin grounded outlet
- Dimensions: 3(L) x 2(W) x 1.55(D) inches
- Weight: 0.3 ounces
- Warranty: 10 years
- US Patent No.: 6,734,784; 6,784,790; 7,265,654; 7,688,183. U.S. and foreign patents may be pending.
- Mode Descriptions:
- Normal: Power Is applied to device
- Link: Press and Hold Button for > 6 seconds
- Link Exit: Tap while in LINK Mode
- Programming Mode: 3 taps while in LINK Mode
- Programming Mode Exit: Hold Button for 3 sec. while in PROGRAMMING Mode
- Review Mode: 3 taps while in NORMAL Mode
- Reschedule Mode: 4 taps while in LINK Mode
- Clock Review Mode: 8 taps while in NORMAL MODE
- Signal Strength Mode: 6 taps while in NORMAL Mode
- Noise Strength Mode: 7 taps while in NORMAL Mode
- Factory Default: 10 taps while in LINK Mode