ELK Wireless Water Alert Sensor, 319.5 MHz

The ELK Wireless Water Alert Sensor, 319.5 MHz is a water detecting sensor built with a transmitter and remote probe that are attached by a 6-foot cable and is specifically designed to report the presence of water when it comes into contact with the probe. This sensor is compatible with E27 Alarm Engine, M1 Controls, and other systems that support 319.5 MHz wireless devices. Code outputs of the sensor are tamper, tamper restore, alarm, alarm restore, and low battery.

• Water detection when liquid makes contact with the probe
• Contacts above floor level to prevent false floor condensation detection
• Constantly checks for water and requires two positive checks for a valid alarm
• Battery checked every hour (takes 2 CR2032 batteries)
• Transmitter has a tamper switch inside

Why You Would Use This Product:

The ELK Wireless Water Alert Sensor, 319.5 MHz is the perfect solution for preventing costly water damage from occurring due to a water leak. It can be placed in areas of a property such as under a sink, near a hot water heater, by a washing machine, or anywhere else water leakage is most probable. This sensor also checks constantly for water and requires two positive checks before a valid alarm, and even though the sensor is sensitive to water, it will not set off an alarm due to condensation or high humidity. Installation is easy, just mount the transmitter on a wall and place the probe on the floor where water leakage is most likely to occur.

In The Box:

• 319.5 MHz Water Sensor
• Mounting Hardware
• 2 x CR2032 Batteries
• Instructions

NOTE: The ELK-319WA water sensor is not a self- contained warning sensor device. For proper operation, it must be used in conjunction with a compatible learn-mode 319.5 MHz alarm control panel.