WaterCop Wireless Flood Sensor, 2 Probes

Newly redesigned WaterCop Classic flood sensors are placed in areas that are susceptible to leaks such as water heaters, washing machines, ice makers/refrigerators, sinks and toilets. When water contacts the sensor, a wireless signal is sent to the WaterCop Classic shut-off valve installed on the main water supply to close and stop the flow of water to the leak point.

• Battery or AC (optional) powered.
• Transmits wireless signal to valve when moisture is detected.
• Unlimited number can be used, placed anywhere.

WaterCop Classic sensors communicate only with the WaterCop Classic shut-off valve. Sensors require two (2) 'AA' batteries or optional WPA power adapter to operate. To increase wireless range, order WPR repeater.

Each WaterCop system can support an unlimited number of flood sensors. A sensor consists of a transmitter (a rectangular box with an antenna) and a sensor probe (a small disc at the end of the wire, with two short gold prongs protruding from one side).

The transmitter in the flood sensors and the receiver in the WaterCop communicate by radio frequency. The smaller the distance between them, the stronger the signal will be. The maximum transmission distance will be in the 150- to 200-foot range. The sensor may be secured with adhesive tape.

NOTE: Does not include valve, power supply, or batteries.